Page 1 of 1

F-150 pulls a train

Posted: Thu Jul 25, 2019 12:01 am
by GP30M4216
Not as crazy as you might think! Note the TTC Flexity streetcar visible in the yard in the final frame at the end. Also, I wonder if the placement of that TOUGH! autorack was intentional? :lol:

https://www.at.ford.com/en/homepage/new ... f1500.html

Re: F-150 pulls a train

Posted: Thu Jul 25, 2019 6:15 am
by AARR
Watched this on LinkedIn too 8)

Re: F-150 pulls a train

Posted: Sun Jul 28, 2019 6:28 pm
by M.D.Bentley
NICE PR stunt :-) . But not as hard as it looked. :-( . Cars are designed to roll. All you need is level ground. I would still like to see one. Worked in a railcar shop some years ago. Couple of spots in the shop, the tracks were (DNL). If you didn't block/chock/brake the cars they would take off when you leaned on em 8-).

Re: F-150 pulls a train

Posted: Tue Jul 30, 2019 12:27 pm
by EWRice
A couple years ago when I still played with trains, I watched the wind blow an empty centerbeam up the hill I was trying to roll it down past the switch. It was gusty but not straight line winds or anything. I ended up having to push the car by hand down the hill to overcome the wind. They definitely role easier than most people think. As long as the bearings are good and brakes aren't hanging up.

Re: F-150 pulls a train

Posted: Wed Jul 31, 2019 10:24 am
by ~Z~
Engineering Explained shows why it's easy to pull the rail cars as compared to pulling 1 million pounds of trucks on rubber tires: https://www.youtube.com/watch?v=Au3U72CX74I

Re: F-150 pulls a train

Posted: Fri Aug 09, 2019 6:54 am
by PatAzo
There's no school like old school. In the 1930's Timken equipped a 4-8-4 "Four Aces" will all roller bearings to demonstrate the low rolling resistance of roller bearings vs. plain bearings. Their PR events included brining staff from depot offices out to pull the locomotive with rope. The most famous is three secretary's pulling the Four Aces in Chicago.

Image